top of page

Bullet Raceway and Hobbies
Race Track in Woodruff, South Carolina
Chicagoland Raceway
17 West Ogden Ave
Westmont, IL 60559
Mid America Raceway Naperville
1223 east ogden ave suite 139
Naperville, IL 60563
Bent Wrench Racing
7104 Forest Hills Rd, Loves Park, IL 61111
At The Track Raceway
2026 Ironwood Cir
South Bend, IN 46635
Thazer Raceway
2925 Mishawaka Ave
South Bend, IN 46615
ProSlot LLC.
12 W Main St, Hartford, MI 49057
Shop B&E Slotsport products from these commercial slot car raceways:
B&E Slotsport 1/24 Scale Hobbystock rollers

Crusader Hobbystock roller
Discontinued
Best for those just looking to get started.
NEW ProSlot 4001 motor with purple seal. 100 turns at 0 degree timing, these cars are considerably easier to drive than our 4002 powered cars.
1-1/16" B&E Supercomp tires out back, B&E Ultralight fronts.
4.5" wheelbase.
7/33 gearing.
Body mounts are positioned for you to fit most 1950's era model car bodies.

Eliminator Hobbystock roller
Discontinued
Eliminator 4.5" inches length wheel base.
Ultralight Soft rear tires and ProSlot 4001S motor.Built Eliminator frame for hard body racing. 4.5" wheelbase with body mounts positioned to fit most Revell/Amt body kits. Best suited to fit Mid American Superstock and Hobbystock division bodies.

1/24 Scale Eliminator Chassis Built
Discontinued
4.5" wheelbase with body mounts positioned to fit most Revell/Amt body kits. Best suited to fit Mid American Superstock division bodies. This is built from our Eliminator kit. Material is .042 thick nickel plated spring steel with soldered joints.

"Berdugo" chassis kit
Discontinued
042 plated spring steel. Can be built 4.25 to 4.75 wheelbase.


"Silverback" chassis kit
The "Silverback"
.040 super duper brass material with silver finish. Roughly 40% stronger than traditional brass options.
The "Kerfs" on the front and rear uprights are gone for superior strength.
Better solderability.
4-3/8" to 4-5/8" wheelbase.
Room for adjustment to run your selected .950 to 1" diameter Mid American series tire sizes...without grinding the chassis.
Holes provided in the uprights below the front axle for you to get creative with bracing.
bottom of page